EUTECH INSTRUMENTS ALPHA RES 1000 RESISTIVITY CONTROLLERTRANSMITTER Instruction Manual download pdf (Page 9)

1.3 Safety instructions

− The Alpha pH 2000 should be installed and operated only by

personnel familiar with the transmitter and who are qualified for

such work.

− A defective controller must neither be installed nor put into

service.

− The Alpha pH 2000 must only be operated under the specified

operating conditions (see section 8).

− The Alpha pH 2000 must not be repaired by the customer.

− The Alpha pH 2000 must only be opened to replace the unit fuse

or to set the jumper for Pt100/Pt1000 temperature sensor. This

work must be carried out only by personnel familiar with the

transmitter and who are qualified for such work. Make sure the

mains cable is separated from the power supply before opening

the unit.

− No modifications to the Alpha pH 2000 are allowed. The

manufacturer/supplier accepts no responsibility for damage

caused by unauthorised modifications. The risk is borne entirely

by the user.

1.4 Putting out of service / Correct disposal of the unit

Putting out of service

• First disconnect the unit from the mains, then undo all electrical

connections.

• Remove the unit from the wall / panel.

Correct disposal of the unit

When the transmitter is finally taken out of service, observe the local

environmental regulations for correct disposal or send the transmitter to your

local Eutech Instruments distributor, they will take care of proper disposal.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

No comments

EUTECH INSTRUMENTS ALPHA RES 1000 RESISTIVITY CONTROLLERTRANSMITTER Instruction Manual Page 9