EUTECH INSTRUMENTS ALPHA COND 500 - REV 4 Installation Manual download pdf (Page 10)

MN100003 REV A (12/07/10)

Page 10

Display of the VibraCheck II:

1. Bias Indicator: The Bias indicator is located on the left side of the display. The VibraCheck Limited and

VibraCheck II continuously monitors the bias condition of the ICP accelerometer and indicates the status on the

display. There are 3 conditions: OK, High and Low.

OK: ICP bias is in the normal range, everything is working correctly including the cable.

High: Usually the sensor or cabling is not connected to the meter.

Low: The ICP circuit is shorted. Check the cabling immediately.

 Caution: Do not operate the meter when you observe a high or low bias condition. Inspect and replace as

required.

1. Bias Indicator status:

OK-

Open-

Short-

4. Battery Indicator

3. Vibration units and

method of detection

2. Numerical value of the

vibration level

5. Hold, Gain,

Average or Peak and

memory review modes –

V=Pod II only

6. Storage location label for point storage or

route based data collection storage- V-Pod II

only

7. Stored data indicator

V-Pod II only

Low

High

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

EUTECH INSTRUMENTS ALPHA COND 500 - REV 4 Installation Manual Page 10