EUTECH INSTRUMENTS WP PCD 650 Instruction Manual download pdf (Page 82)

Instruction Manual PCD 650

4.1.3 Modifying Setup parameters

Follow the steps below to modify setup parameters, when you enter a setup

sub-group.

1. Press NEXT (F3) key to select individual setup parameters sequentially.

2. Press

(Up) or (Down) arrow key to change the value of a selected

parameter.

3. Once you changed a value:

• Press ENTER key to save the change, or

• Press NEXT (F3) key to go to the next parameter without saving the

changed parameter.

4. Press NEXT-P (F2) or PRE-P (F1) to navigate to next or previous page.

5. Press ESC (F4) to exit from setup mode.

Function Keys available in setup sub-group screens:

PRE-P (F1)

Goes to the previous page of the same sub-group

NEXT-P (F2)

Goes to the next page of the same sub-group

NEXT (F3)

Goes to the next parameter of the same sub-group

ESC (F4)

Goes to measurement mode

Modify the selected parameter value

ENTER

Confirms/saves the changes made to the currently selected parameter

and then goes to the next parameter of the same sub-group

(Not functional)

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 119 120

No comments

EUTECH INSTRUMENTS WP PCD 650 Instruction Manual Page 82