EUTECH INSTRUMENTS ALPHA CON 500 2-WIRE TRANSMITTER Instruction Manual download pdf (Page 35)

Instruction Manual αlpha CON 2000

6.8 Wash relay (WASH) sub-function

In this sub-function you set the parameters for the wash relay.

SETUP

HOLD

ENT

SETUP

SETUP SETUP

HOLD HOLD HOLD

444

ENT

ENT ENT

ENT

SETUP

HOLD

1. Select the “WASH” sub-function, then press the ENT key.

2. Enabling/disabling wash function: press the ▲ or ▼ key to enable (WASH ON) or

disable (WASH OFF) wash function. Press the ENT key to confirm your selection.

3. Selecting the relay status condition: press the ▲ or ▼ key to choose desired relay

status (de-energised = “DEEN” or energised = “EN”). Press the ENT key to confirm your

selection.

4. Setting the wash interval in hours: Press the ▲ or ▼ key to set the desired wash

interval (setting range: 0.1 to 199.9 hours). Press the ENT key to confirm your setting.

5. Setting the wash duration in seconds: Press the ▲ or ▼ key to set the desired wash

duration (setting range: 1 to 1999 seconds). Press the ENT key to confirm your setting.

Note: During wash cycle the transmitter is set to HOLD. For safety reasons, the

HOLD function is activated 5 seconds prior and deactivated 10 seconds after the

wash cycle.

Continue with Setup mode procedures, or return to Measurement mode by pressing the ▲

and ▼ keys simultaneously (escape).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

No comments

EUTECH INSTRUMENTS ALPHA CON 500 2-WIRE TRANSMITTER Instruction Manual Page 35